Akio Makishima et al. (2011) Simultaneous Determination of Cd, In, Tl and Bi by Isotope Dilution‐Internal Standardisation ICP‐QMS with Corrections Using Externally Measured MoO+/Mo+ Ratios , Geostandards and Geoanalytical Research, 35, 57 - 67, doi:10.1111/j.1751-908X.2010.00054.x. < 20191002142745-877448 > pub
Table 3. Analytical results for Cd, In, Tl and Bi obtained in this study < 20191002150024-480190 > pub
measured unit JB-2 JB-3 powder JA-1 JA-2 JA-3 powder JP-1 BHVO-1 AGV-1 PCC-1 DTS-1
[Cd] a µg/g 0.141 0.111 0.097 0.073 0.085 0.009 0.112 0.09 0.014 0.007
[In] a µg/g 0.069 0.064 0.043 0.035 0.04 0.003 0.077 0.038 0.003 0.002
[Tl] a µg/g 0.037 0.047 0.092 0.354 0.21 0.008 0.064 0.308 0.007 0.008
[Bi] a µg/g 0.027 0.031 0.004 0.083 0.037 0.003 0.01 0.036 0.005 0.004
(a) determined by Q-ICP-MS_procedures of Makishima and Nakamura (1997, 1999, 2006) on Q-ICPMS Agilent 7500cs
name physical-form quantity unit global-id
JB-2 pub powder 20130416090250-887738
JB-3 powder pub aliquot 1.56 g 20170620122529-773001
JA-1 pub powder 20130416090234-228760
JA-2 pub powder 20160921101920-406882
JA-3 powder pub aliquot 1.9 g 20170620122603-026842
JP-1 pub powder 12.8 g 20190301111946-454924
BHVO-1 pub powder 20130416090323-009811
AGV-1 pub powder 20130416090329-701068
PCC-1 pub powder 20100824093541348.hkitagawa
DTS-1 pub powder 20140606085058-007340

The table is created from analysis shown below. The rowname Cd, In, Tl and Bi for std (Makishima et al., 2010) filters out analysis. Upper analysis has priority.To list more analysis, add a stone in stone sub-tab.

  • name
    technique
    device
    priority
JB-2 JB-3 powder JA-1 JA-2 JA-3 powder JP-1 BHVO-1 AGV-1 PCC-1 DTS-1